Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 48

PowerBoss

The Power of Clean

CASTER ADJUSTMENT

1. If only caster adjustment is required, stop the engine and set the parking

brake.

2. Loosen the wing nuts on top of the caster stems. Turn the caster stems to

raise or lower the casters. If too much flare was experienced, lower the caster.

If too little flare was observed, raise the casters. Adjust the casters so that both

are equal in adjustment.

3. Tighten the wing nuts without disturbing the adjustment.

4. Retest the squeegee.

PITCH ADJUSTMENT

If the pitch adjustment is required, it is usually easiest to adjust both pitch and casters

at the same time.

1. Park the machine on a level floor and set the parking brake. Turn the engine

off.

2. Loosen the wing nuts on top of the caster stems and adjust the casters up

several turns. Leave loose.

3. Locate the pitch adjusting screws on the squeegee support arm. There are two

adjusting screws. Loosen all four locking nuts (2 per screw) and back the nuts

away from the bracket several turns.

4. At the forward end of each adjusting screw, locate and loosen the pivot bolts

and nut. Do not remove the nuts.

5. With the hardware loosened, crank the engine, set the throttle to medium

speed. Turn the steering wheel completely to the right. Be sure that the

parking brake is locked. Lower the squeegee.

6. With the squeegee rubber resting on the floor, check that the rear rubber is

standing on the floor and making contact throughout its width. If not, lift and

drop by hand until contact is made across.

7. With the squeegee in this position, turn all four locking nuts by hand until they

are snug against the bracket. Do not wrench tighten yet.

8. Using a ¼” drill bit as a gage, lower both casters until the ¼” drill bit can pass

between the wheel and the floor.

SERVICE INSTRUCTIONS (CONTINUED)

SCRUB & WATER PICK-UP COMPONENTS

NOTE

Only the pivot bolts attached to the ends of the adjusting bolts

need to be loose. Do not loosen other pivot bolts.