Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 51

PowerBoss

The Power of Clean

SERVICE INSTRUCTIONS (CONTINUED)

HOPPER

FILTER REMOVAL

1. Raise the hopper cover.

2. Pull out both levers stored on the front of the filter retaining bracket.

3. Push down on both levers at the same time to open and lock the filter

retaining bracket.

4. Slide the filter forward to remove.

FILTER CLEANING

The dust control filter is a permanent type paper element filter. It may be vacuumed, blown

out with compressed air, tapped against the floor or washed with soap and water.

1. If blown out with compressed air, use 100 psi or less.

2. If washed with soap and water, use 40 psi water pressure or less.

FILTER REPLACEMENT

1. If the retainer bracket is closed, push down both handles until the bracket

opens and locks.

2. Install the panel filter. Make sure the filter is positioned all of the way in the

bracket. Gasket should be on the bottom.

3. Unlock the retainer bracket and close by lifting up on the retainer bracket

handles.

4. Pivot the handles in against the filter to their stored position.

5. Close the hopper cover.

NOTE

Make sure the filter is thoroughly dried while standing on its

side before installing in the hopper. Do not install or use a wet

filter.