Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 54

PowerBoss

The Power of Clean

BRAKE ADJUSTMENT

1. Park the machine on a level surface and turn on the scrubdeck to lower the

brushes to the floor. Turn off the engine.

2. Chock both sides of the right front tire.

3. Adjust the brakes for wear by locating the brake adjustment turnbuckle. This

is located beneath the frame to the rear of the brake equalizing bar and

directly below the brake pedal.

4. Using a 9/16” open end wrench loosen the locking nut positioned against the

rear clevis. Back the nut away from the clevis several turns.

5. Using the 9/16” wrench, turn the threaded bar by grabbing the hex section at

the center. If view from the rear of the machine, turning the bar

counterclockwise will tighten the brakes. Rotate the turnbuckle bar two full

turns.

6. Retighten the locking nut against the rear clevis.

7. Test the brakes. Readjust if required.

TIRES

CHANGING SOLID TIRES

1. Remove the tire from the vehicle by removing the five inner lug nuts.

2. Remove the five flathead bolts and nuts.

3. Press the tire from the rim.

4. Press the large rim half into the new tire.

5. Mount the small rim half and secure with flathead bolts.

6. Reinstall the tire on the machine.

SERVICE INSTRUCTIONS (CONTINUED)

BRAKES & TIRES

NOTE

The procedures which follow apply to SOLID TIRES ONLY.