User manual

Smart-Switch
- 5 -
The voltage monitor setting is changed using the sensor button. You simply hold the button
pressed in until the LED indicates the correct setting in setup mode:
- LED flashes green once = LiPo
- LED flashes green twice = five-cell battery
- LED flashes green three times = four-cell battery
Now we come to the procedure for setting the voltage monitor circuit:
- Hold the sensor button pressed in
- After about one second the color of the LED changes to orange
- After a further three seconds the color of the LED changes to red
- After a further five seconds the LED goes out briefly - now watch carefully!
- The LED emits one brief green flash: release the button now, and the switch is set to
voltage monitoring for LiPo batteries.
- If you continue to hold the button pressed in, the LED emits two brief green flashes:
release the button now, and the switch is set to voltage monitoring for a five-cell NC or
NiMH battery.
- If you still continue to hold the button pressed in, the LED emits three brief green
flashes: release the button now, and the switch is set to voltage monitoring for a four-
cell NC or NiMH battery.