User manual

Smart-Switch
- 7 -
Even though our product is very well protected >from the effects of vibration, the Smart-
Switch should always be mounted in a part of the model where vibration levels are
relatively low.
Please note the following point:
The GRP fuselage sides of a large power model are not suitable for mounting the Smart-
Switch - nor any other type of switch - as they are always subject to considerable vibration.
You can remedy the situation by cutting a ply plate (2.5 - 3 mm thick) about 2 - 3 cm larger
than the switch aperture, and gluing it over the inside of the opening.
The plate damps the vibration, and at the same time provides plenty of “meat” for the switch
retaining screws to bite into.