Product Manual
45
Assembly Instructions
Step 10 – Horizontal Latch Bracket Assembly
• Install the horizontal latch bracket to the beam assembly in orientation
shown below, using (2) bolts and (2) nuts.
• Torque to 71 ft.-lb.
• Remove lynch pin from vertical pin and pull out vertical pin.
• Pivot beam to horizontal position, ensure horizontal latch pin locks
into the horizontal latch bracket.
• Note: If latch pin does not properly lock into horizontal latch bracket,
loosen bolts and adjust until latch pin locks. Torque bolts after
adjustment.
• Insert vertical pin and secure with lynch pin.
Tools Needed
• 18mm Wrench
• Torque Wrench
Fasteners Needed from Parts Bag:
Horizontal Latch to Beam
M12-1.75 Nut
Qty: 2
Horizontal Latch to Beam
M12-1.75 X 35mm Bolt
Qty: 2
Bolts
Horizontal
Latch
Bracket
Nuts
Horizontal
latch pin