Product Manual
49
Assembly Instructions
Step 14 -Fittings
• Remove plug from cylinder port and discard
• Lubricate O-ring and threads on fitting with clean oil
• Orientate (1) Valve Fitting so that nut/washer/O-ring assembly is
facing up. Turn fitting into cylinder port until finger-tight
• Torque to 27-43 ft.-lb.
• Looking at fitting from end with nut/washer/O-ring assembly, turn nut
clockwise as far as possible
• Use valve port marked “A” to thread the control valve onto the fitting
until control valve touches washer
• Hold control valve in orientation shown below and torque nut to 37-46
ft.-lb.
Tools Needed
• 7/8” Wrench
(2 needed)
OR
• Crescent Wrench
(2 needed)
• Torque Wrench
Fittings Needed from Parts Bag:
Valve Fitting
Cylinder Port
Valve Port
Part # 790488
Valve Fitting
Qty: 1
Nut
Washer
O-Ring
Into
Cylinder
Valve to
Cylinder Hose
Cylinder