Product Manual
50
Assembly Instructions
Step 15 - Fittings
• Remove plugs from ports in control valve
• Lubricate O-ring and threads on fitting with clean oil
• Looking at fitting from end with nut/washer/O-ring assembly, turn nut
clockwise as far as possible
• Using wrench, turn (1) Valve to Cylinder Hose Fitting into valve port
marked “B” until washer touches control valve. Continue turning until
washer touches thread nearest wrench pad
• Back off fitting counterclockwise not exceeding one revolution until it
is oriented in the correct position
• Place wrench on the wrench pad of fitting to prevent fitting from
turning and torque nut to 37-46 ft.-lb.
• Thread Valve to Cylinder Hose Fitting Nut on to Valve to Cylinder
Hose.
• Place wrench on hose end fitting to prevent from turning and torque
Valve to Cylinder Hose Fitting Nut to 27-34 ft.-lb.
•
Tools Needed
• 7/8” Wrench
• 3/4” Wrench
• 1” Wrench
OR
• Crescent Wrench
(2 needed)
• Torque Wrench
Fittings Needed from Parts Bag:
Valve to Cylinder
Fitting
Valve to
Cylinder
Hose
Valve Port
Part # 778827
Valve to Cylinder Hose Fitting
Qty: 1
Nut
O-ring
Washer