Replacement Part List
Table Of Contents
- PM7500-PM9400E Portable Generator Owner’s Manual
- Table of Contents
- Section 1 Introduction and Safety
- Section 2 General Information and Setup
- Section 3 Operation
- Operation and Use Questions
- Before Starting Engine
- Prepare Generator for Use
- Grounding the Generator When Used as a Portable
- Know Generator Limits
- Transporting/Tipping of the Unit
- Starting Pull Start Engines
- Starting Electric Start Engines (if equipped)
- Low Oil Level Shutdown System
- Charging the Battery (electric start units only)
- Section 4 Maintenance and Troubleshooting
- Part No. A0000061814
- Generador portátil PM7500-PM9400E Manual del propietario
- Índice
- Sección 1 Introducción y seguridad
- Sección 2 Información general y configuración
- Sección 3 Operación
- Preguntas sobre la operación y el uso
- Antes de arrancar el motor
- Preparación del generador para su uso
- Conexión a tierra del generador cuando se utilice como equipo portátil
- Conozca los límites del generador
- Transporte/inclinación de la unidad
- Arranque de motores de arranque retráctil
- Arranque de motores de arranque eléctrico (si están equipados)
- Sistema de cierre por nivel bajo de aceite
- Carga de la batería (solo unidades de arranque eléctrico)
- Sección 4 Mantenimiento y solución de problemas
- N.° de pieza A0000061814
- Génératrice portable PM7500-PM9400E Manuel de l’utilisateur
- Table des matières
- Section 1 Introduction et sécurité
- Section 2 Généralités et configuration
- Section 3 Fonctionnement
- Questions concernant le fonctionnement et l’utilisation
- Avant de démarrer le moteur
- Préparer la génératrice à l’utilisation
- Mise à la terre de la génératrice lors d’une utilisation portable
- Connaître les limites de la génératrice
- Transport et inclinaison de la machine
- Démarrer un moteur à lanceur à rappel
- Démarrer un moteur à démarreur électrique
- Système d’arrêt en cas de faible niveau d’huile
- Recharger la batterie (modèles à démarreur électrique seulement)
- Section 4 Entretien et dépannage
- Réf. A0000061814
20 Owner’s Manual for Portable Generator
Troubleshooting
PROBLEM CAUSE CORRECTION
Engine is running, but
AC output is not
available.
1. Circuit breaker OPEN.
2. Poor connection or defective
cord set.
3. Connected device is bad.
4. Fault in generator.
5. GFCI receptacle is OPEN (if
equipped).
1. Reset circuit breaker.
2. Check and repair.
3. Connect another device that is
in good condition.
4. Contact IASD.
5. Correct ground fault and press
reset button on GFCI recepta-
cle (if equipped).
Engine runs well at
no-load, but bogs when
load is applied.
1. Short circuit in a connected
load.
2. Generator is overloaded.
3. Engine speed is too slow.
4. Shorted generator circuit.
5. Clogged spark arrestor.
1. Disconnect shorted electrical
load.
2. See
Know Generator Limits.
3. Contact IASD.
4. Contact IASD.
5. Clean spark arrestor screen.
Engine will not start; or
starts and runs rough.
1. Fuel shut-off is OFF.
2. Dirty air filter.
3. Out of fuel.
4. Stale fuel.
5. Spark plug wire not connected
to spark plug.
6. Bad spark plug.
7. Water in fuel.
8. Overchoking.
9. Low oil level.
10. Excessive rich fuel mixture.
11. Intake valve stuck open or
closed.
12. Engine lost compression.
13. ON/OFF switch (if equipped) is
in OFF position.
1. Turn fuel shut-off ON.
2. Clean or replace air filter.
3. Fill fuel tank.
4. Drain fuel tank and fill with
fresh fuel.
5. Connect wire to spark plug.
6. Replace spark plug.
7. Drain fuel tank; fill with fresh
fuel.
8. Set choke to no choke posi-
tion.
9. Fill crankcase to correct level.
10. Contact IASD.
11. Contact IASD.
12. Contact IASD.
13. Move switch to ON position.
Engine shuts down
during operation.
1. Out of fuel.
2. Low oil level.
3. Fault in engine.
4. COsense shut-off due to accu-
mulating carbon monoxide if a
red light blinks on the side
panel badge.
5. COsense shut-off due to a
system fault if a yellow light
blinks on the side panel
badge.
1. Fill fuel tank.
2. Fill crankcase to correct level.
3. Contact IASD.
4. Follow all safety instructions
and relocate generator to an
open area outside, far away
from windows, doors and
vents.
5. Start to confirm yellow light
blinks when/if generator shuts-
off. If COsense continues to
fault and shut-off, contact
IASD.
Engine lacks power. 1. Load is too high.
2. Dirty air filter.
3. Engine needs to be serviced.
4. Clogged spark arrestor.
1. Reduce load (see
Know Gen-
erator Limits).
2. Clean or replace air filter.
3. Contact IASD.
4. Clean spark arrestor screen.
Engine surges or
stumbles.
1. Choke is opened too soon.
2. Carburetor is running too rich
or too lean.
1. Set choke to halfway position
until engine runs smoothly.
2. Contact IASD.