Use and Care Manual

ManualsBrandsPowermate ManualsAir Compressors, Tools & AccessoriesCompact 1/2 in. Air Impact Wrench

4 - ENG

OPERATING INSTRUCTIONS

TYPICAL INSTALLATION

To begin using the tool:

1. As a standard practice, drain water

Figure 2

A 1/2” Square drive

B Trigger

C Exhaust port

D Teflon tape

E Male connector

F Air inlet port

G Torque regulator

H Forward/Reverse switch

from the air compressor tank and air

lines prior to use each day

(reference your compressor

operators manual for detailed

instructions).

2. Install a 1/4” NPT male connector

(not included) into the air inlet port

on the tool (see Figure 2).

Note: Use Teflon® Tape on all

threaded connections.

3. Turn on the air compressor and

allow it to build up pressure.

4. Adjust the air compressor’s regulator

or the supply line regulator to 90

PSI.

5. Adjust the torque on the impact

wrench by turning the torque

regulator knob clockwise to the

desired torque setting (1 = minimum

torque/ 3 = maximum torque) (see Figure 2a). Set the torque regulator knob to 3

Figure 2a

(maximum setting) to remove nuts. NOTE: Do not use the air impact wrench

to set torque. Always use a torque wrench to set torque.

6. Attach the desired 1/2” square drive impact socket.

Always use impact-type sockets and extensions that are

designed for impact wrenches. Hand tool sockets will shatter and potentially

cause personal injury and/or property damage.

7. Connect the tool to the air hose quick coupler. NOTE: It is recommended that

a whip hose with a swivel (P012-0079SP - not included) be used to prevent

twisting, kinking and excessive wear to the air hose (ref. item “F” in figure

1 for recommended connections).

8. Select the tool rotation direction. Push the forward/reverse switch to the left for forward or the right for

reverse.

9. Press the trigger to operate the tool and release the trigger to stop the tool.

Disconnect the tool from the air supply before lubricating or changing sockets.

Key Description Key Description Key Description Key Description

A Air hose D In-line Oiler G Quick Coupler J Female Connector

B In-line Filter E Air Hose H Male Connector K Spray Gun

C Tee Fitting F Whip Hose I Air Tool

Figure 1