Use and Care Manual

32
Symptom Possible Cause Correction *
Controller screen is dim.
(When connected to
computer via USB cable,
screen is bright.)
Not connected to power supply, or
power supply damaged.
Check DC24V power supply output. If okay,
check cable from power supply to interface
board.
50-pin cable is damaged, or interface is
broken.
Replace.
Controller screen is dim.
(When connected to
computer via USB cable,
screen is also dim.)
Crystal processor in controller is
damaged.
Have controller repaired or replaced.
Incorrect (high) voltage power supply
applied to controller.
Have controller repaired or replaced.
Screen displays “Spindle
On” when spindle is off;
and displays “Spindle Off”
when it is on.
Improper connection on interface
board.
Rewire correctly.
Table 7
15.0 Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-855-
336-4034
Monday through Friday, 8:00 a.m. to 5:00 p.m., CST. Or e-mail: [e-mail]. Having the
Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and
accurately.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from
Powermatic. Some parts are shown for reference only, and may not be available individually.