Use and Care Manual

ManualsBrandsPowermatic ManualsToolsPM2014 Woodworking Lathe Work Light

Powermatic

427 New Sanford Road

LaVergne, Tennessee 37086 Document No. M-6294924

Ph.: 800-274-6848 Edition 1 04/2020

#6294924, LED lamp with PM2014 bracket

WARNING: This product can expose you to chemicals including lead which is known to the State of California to cause

cancer and birth defects or other reproductive harm. For more information go to http://www.p65warnings.ca.gov.

WARNING: Drilling, sawing, sanding or machining wood products generates wood dust and other substances known to

the State of California to cause cancer. Avoid inhaling dust generated from wood products or use a dust mask or other

safeguards for personal protection. Wood products emit chemicals known to the State of California to cause birth defects or

other reproductive harm. For more information go to http://www.p65warnings.ca.gov/wood.

This accessory, when mounted to the bracket, is designed

for use with the Powermatic model PM2014 Lathe.

Contents of container:

1 LED lamp

Mounting bracket

2 Socket head cap screws M12

4 Pan head screws M4

1 Instruction sheet

Assembly and operation

See Figure 1.

1. Mount the bracket to the two threaded holes atop the

lathe head with the socket head screws, and tighten.

2. Mount the lamp to the bracket with the four pan head

screws, and tighten.

Loosen hand knobs to adjust lamp position. Tighten knobs

to secure in position. The LED head can be rotated on its

own axis until it contacts the stop pin.

Before turning on lathe, make sure

spinning workpiece will not contact lamp. Ensure that

hand knobs are tight to prevent lamp from migrating

into workpiece during operation.

GROUNDING INSTRUCTIONS

This tool must be grounded. In the event of a malfunction

or breakdown, grounding provides a path of least

resistance for electric current to reduce the risk of electric

shock. This tool is equipped with an electric cord having an

equipment-grounding conductor and a grounding plug. The

plug must be plugged into a matching outlet that is properly

installed and grounded in accordance with all local codes

and ordinances.

Figure 1

Do not modify the plug provided - if it will not fit the outlet,

have the proper outlet installed by a qualified electrician.

Improper connection of the equipment-grounding

conductor can result in a risk of electric shock.

The conductor with insulation having an outer surface that

is green with or without yellow stripes is the equipment-

grounding conductor. If repair or replacement of the electric

cord or plug is necessary, do not connect the equipment-

grounding conductor to a live terminal.

Check with a qualified electrician or

service personnel if the grounding instructions are not

completely understood, or if in doubt as to whether the

tool is properly grounded. Failure to comply may

cause serious or fatal injury.

Use only 3-wire extension cords that have 3-prong

grounding plugs and 3-pole receptacles that accept the

tool's plug.

(continued)

Summary of content (2 pages)

PAGE 1
#6294924, LED lamp with PM2014 bracket WARNING: This product can expose you to chemicals including lead which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to http://www.p65warnings.ca.gov. WARNING: Drilling, sawing, sanding or machining wood products generates wood dust and other substances known to the State of California to cause cancer.
PAGE 2
Repair or replace damaged or worn cord immediately. The temporary adaptor should be used only until a properly grounded outlet (sketch A) can be installed by a qualified electrician. The green colored rigid ear, lug, or the like extending from the adaptor must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adaptor is used, it must be held in place by a metal screw.