Product Manual
Table Of Contents
- Straight Line Rip Saw
- IMPORTANT SAFETY INSTRUCTIONS
- Table of Contents
- Specifications
- Features
- Receiving
- Installation
- Adjustments
- Operation
- Maintenance
- Optional Accessory
- Troubleshooting
- Replacement Parts
- Parts List: Infeed Body Assembly
- Infeed Body Assembly
- Parts List: Arbor Spindle Assembly
- Arbor Spindle Assembly
- Parts List: Motor and Drive Unit Assembly
- Motor and Drive Unit Assembly
- Parts List: Laser Assembly (Optional Accessory)
- Parts List: Roller and Frame Assembly
- Roller and Frame Assembly
- Table and Stand Assembly
- Parts List: Electrical Control Panel (SLR12-443)
- Electrical Connections
- Preventive Maintenance
- Warranty and Service
32
Preventive Maintenance
Checklist for Model SLR12 Straight Line Rip Saw
[ ] Work area around machine marked off clearly.
[ ] Non-skid floor strips in area where operator normally stands.
[ ] Inspect entire machine for loose bolts, nuts, screws. Tighten and replace as necessary.
[ ] Clean table area, removing sawdust and chips with a soft bristle brush. Remove gum and pitch
with oven cleaner.
[ ] Lubricate appropriate places with a good grade non-hardening grease.
[ ] Clean table and fence surface. If rusted, use paste mixture of household ammonia, a good
commercial detergent and 000 steel wool. Wash surface down with hot, soapy water, rinse and
dry thoroughly. Coat surface with talcum powder, rubbing briskly into surface with a clean
blackboard eraser.
[ ] Check blade condition; should be sharp and free of nicks or grooves.
[ ] Check belt condition. Replace as needed. Dress with parafin. Check belt tension.
[ ] Check motor for loose wiring and sawdust congestion, pulleys tight and in line.
[ ] Check bearings. Replace any bad or suspect bearings immediately.
[ ] Fence properly aligned with blade.