Operation Manual

Step 2: assembling support tube & the front plastic cover

A: Insert the support tube (10) to the front plastic cover (9) and

then connects the sensor A1&A2 and tension control wire as

shown in FIG.2,

B: Install the support tube (10) on the main frame with arc washer

(3) and bolt (7).

C: Lock the balance bolts on the main frame then put down the

front plastic cover (9).

Attention: Tighten the bolt (7) and the arc washer (3) after the

STEP 3

Step 3: assembling the handlebar

B. Put the handlebar (13) on the bind cap (18) of the

supporting tube and adjust the comfortable angle,

then install the bind cap (18).

C. Insert the knob (19) on the spring washer (8) and

then put the handlebar (13) on the main frame.