Operation Manual

POWXG4050 EN

9 USE

9.1 Fueling

MOTOR FUEL: mix the petrol and oil at 40:1only – 2 stroke

 Use fresh unleaded petrol. You must use 100% synthetic oil specifically made for heavily

stressed two stroke engines.

 Mix the petrol and oil in an approved container. Never mix fuel directly in the line trimmer

fuel tank.

 Place the brush cutter upright on the ground or on a sturdy bench and wipeany debris

from around the fuel cap.

 Unscrew the fuel tank cap and pour the mixture into the tank with the aid of a funnel.

 Be careful not to spill any mixture. If this happens, wipe the spill with a clean rag.

 Start the engine at least three metres away from the area where the fuel tank has been

filled up in order to avoid any risk of fire.

9.2 Use

To reduce the risk of injury, safety switches are installed for the nozzle and

quick release collect bag. The Blower/Vac can not be turned on unless the

nozzle and quick release collect bag are attached.

1.Set the mode selection lever (7) to the

right position Ensure the level have clicked

to place and is rotated to the furthest point.

2.Push the switch (6) to power on marked

“I”.