User Manual

POWXG9007 EN
Copyright © 2013 VARO NV P a g e | 11 www.varo.com
10.7 Connect the nozzle
Connect the nozzle to the lance using the
quick release connector this allows the quick
and easy changing of nozzles. To connect a
nozzle slide the collar back towards the gun,
push the nozzle into the end of the lance.
Release the collar to lock the nozzle into
position. To disconnect a nozzle slide the
collar back towards the gun, the nozzle can
now be removed.
Note: please be sure that you crosscheck the
correct connection of the nozzle.
Warning: the nozzle is not properly fixed when
the collar doesn’t slide back. Push the nozzle
with high force into the opening, otherwise the
collar doesn’t slide back by itself and the
nozzle is shot out.
10.8 Using the detergent facility
Fill a suitable container with pressure washer detergent. Do not use washing up liquid as it
contains salt. We recommend the use of a good quality pressure washer detergent for use
with this pressure washer. Please follow the instructions on the container.
Most automobile detergents are a combination of a detergent and a wax solution, (wash/wax
liquid). These tend to be a thick viscous liquid. The viscosity (thickness) of the detergent will
increase in cold weather. It is recommended that this type of detergent is diluted with warm
water before filling the container. When using combination wash and wax solutions we
recommend that they are diluted before use. As a general guide we would recommend a
dilution rate of 50/50. However a trial and error process would determine the ideal dilution rate
for a particular detergent.
Notes：
 A thick viscous detergent would not flow freely from the detergent tank and the residue
would cause a blockage in the detergent flow system.
 After using the detergent facility it should be flushed out thoroughly using copious amounts
of water.
To activate detergent delivery, fit the black low pressure nozzle to
the end of the lance. Submerge the end of the detergent suction
tube (picture 3, part 24) into your container of pressure washer
detergent. Suction and mixing will occur automatically as the water
flows through the pump.
11 OPERATING INSTRUCTIONS
11.1 Pressure washer location
 Locate the pressure washer on a solid and level surface so that the engine and pump
crankcase oil lubricate components properly. Avoid areas where puddles are pounded.
Slippery surfaces can cause injuries..
 Locate the machine in a well-ventilated area and away from flammable materials or fumes.
Be sure ventilation warnings are observed. Keep pressure washer at least 18”away from
flammable materials.