User Manual

POWXG9007 EN
Copyright © 2013 VARO NV P a g e | 5 www.varo.com
 Remove the spark plug or cable from the spark plug to prevent accidental starting. When
not in use, or prior to detaching the high pressure hose.
 Do not ware loose clothing, jewellery or anything that may be caught in the engine.
 Keep pets, children and bystanders a safe distance away from your work area. A minimum
of 50 feet is recommended.
 Never point or aim the gun at yourself or anyone else.
 Never put your hand, fingers or body directly in front of the spray nozzle.
 Do not smoke near the pressure washer.
5.3 Correct use and care
 Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
 Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
 Never operate under these conditions:
− A noticeable change in engine speed.
− A noticeable loss of pressure.
− The engine misfires.
− Smoke or flames are present, enclosed compartment.
− Excessive vibration.
− Rain or inclement weather.
 Keep the pressure washer clean and free of oil, mud and other foreign matter.
 Water spray must never be directed towards any electric wiring or directly towards the
pressure washer.
 Use both hands to control the wand.
 Do not allow the hose to come in contact with hot muffler.
 Do not touch nozzle or water spray while operating.
 Do not fill the engine with gasoline when the engine is running, hot or near an open flame.
Do not smoke
 Only approved hoses and nozzles should be used.
 The trigger gun must not lie jammed in position during operation.
 Never lay knots or kink in the high pressure hose.
 All hose connections must be properly connected.
 Prior to starting the pressure washer in cold weather, be sure ice has not formed in any
part of the equipment.
 To prevent accidental discharge of high pressure water, the safety latch on the trigger
should be engaged whenever the pressure washer is not in use (refer to operating
instruction).
 Do not run the pressure washer for more than five minutes without depressing the trigger.
The Pump might get damaged.
 Check the fuel system periodically for leaks or signs of deterioration such as chafed or
spongy hose or missing clamps, or damaged tank or cap. All defects should be corrected
before operation.
 Do not touch hot muffler.
 Service, operate and refuel under the following conditions:
− Good ventilation.
− Refuel the pressure washer in a well lighted area.