User Manual

POWXG9007

P a g e | 8

www.varo.com

9.5 Using the bobbin lock

1. Lock

Pull the lock pin and rotate to the position where the pull ring can get into the lock pin seat.

Then release, and let the lock pin into the howl on the bobbin.

2. Unlock

Pull the lock pin out of the lock pin seat and rotate about 90°, then release.

10 BEFORE OPERATION

To prepare your pressure washer for operation, you will need to perform these tasks:

 Add oil to engine crankcase.

 Add fuel to fuel tank.

 Connect high pressure hose to spray gun and pump.

 Connect water supply to pump.

 Attach nozzle extension to spray gun.

Note: the engine and pump on your new pressure washer will often have an improved

performance after a break of several hours.

10.1 Add oil to the engine crankcase

Do not attempt to start the pressure washer

without filling the engine crank case (picture 3,

part 25) with the proper amount and type of oil

(see technical data). In delivery status the

pressure washer has no oil inside the engine

crank case. Operating the unit without oil will

cause engine damage. Place the machine on a

level surface and remove the oil filler cap.

Add engine oil to at least half of the dipstick

10.2 Add fuel to fuel tank

The pressure washer is powered by a four-stroke

engine (picture 1, part 14), which uses unleaded

petrol fuel.

Use a suitable funnel to fill in the fuel to the

engines fuel tank (picture 1, part 11). Do not spill

any fuel or overfill the tank. The fuel tank should

not be filled above the top of the fuel filter.