Instructions / Assembly

2. Insert the bolts into the aligned holes, with the bolt heads on the

inside of the handle.

3. Install the washers and knobs on the bolts on the outside of the

handle. Tighten firmly by hand.

NOTICE: Do not bend or kink the control cable. The cables should be routed under the Lower

handle and not wrapped around the handle or knobs. The cables must move freely and not bind.

Step 3 – Chute assembly

1. Remove the bolts, washers and nuts from the chute base.

2. Place discharge chute and rotation

handle over discharge hole. Make sure

the rotation handle was locked in

position with discharge chute.

3. Install the bolts from the inside of discharge chute assembly so that the washers and locknuts are on

the outside of the chute. Wrench tighten.

Note: Do not overtighten the locknuts.