Operation Manual

SPECIFICATION CHARTS

FUEL CONNECTION ¼” NPT

FUEL RECOMMENDATION DIESEL FUEL No.1-D or No.2-D ASTM / D975

BATTERY VOLTAGE 12 VOLTS DC

BATTERY CRANKING AMPS 420

BATTERY COLD CRANKING AMPS 590 MINIMUM

BATTERY GROUND NEGATIVE

CHARGING AMPS. 40

FUEL CONSUMPTION IN GALLONS PER HOUR

LOAD PERCENTAGE 20KW 25KW

25% .39 GPH .45 GPH

50% .79 GPH .90 GPH

75% 1.18 GPH 1.35 GPH

100% 1.57 GPH 1.80 GPH

INSTALLATION FACTORS

Each generator set is received as a unit except for the optional exhaust system components,

which are shipped loose for assembly after the set is installed in the vehicle. When preplanning the

installation, the following factors must be considered.

1. COMPARTMENT SIZE: Will there be sufficient room around the set to maintain

the minimum clearance of one (1) inch?

2. AIR REQUIREMENTS: Are the compartment air inlets and outlets sized to allow

adequate circulation of air for cooling and combustion?

3. COMPARTMENT FLOOR: Is the compartment floor strong enough to support the

weight of the generator set?

4. COOLING SYSTEM: Is the cooling system large enough to adequately cool the

generator set? **

5. FUEL SYSTEM: Is the fuel system properly designed to prevent fuel

starvation of either the main engine or generator engine?

6. EXHAUST SYSTEM: Will the exhaust system meet all Local, State and Federal

safety requirements?

7. ELECTRICAL CONNECTIONS: Will all systems, (battery, load and remote switch)

be compatible with the vehicles system?

** NOTE: When using a radiator not supplied by Power Technology consult your radiator

manufacturer to ensure that heat rejection values are met.