User Guide

Communication
43
Powerware
®
FERRUPS FE/QFE UPS (500 VA–18 kVA) User’s Guide : Rev A www.powerware.com
Table 6. DB-25 Port Settings
Specification Standard Setting Adjustable to
Connector 25 pin D (female) wired as DCE.
Format ASCII, 8 bits, 1 stop bit.
Most significant bit set to 0.
Standard setting or
7/8 bits, 1/2 stop
Baud Rate 1200 50–38400
Parity None Odd, Even, or None
Duplex Full Full or Half
4. Turn your terminal on or run your terminal emulation
software. Then press [ENTER] on your keyboard; a prompt
appears on the screen. The prompt varies depending on your
current password level:
=> Normal prompt
User=> User Password has been entered
5. Press [ENTER] on your keyboard a few times to verify that the
UPS responds.
6. To control or monitor the UPS, simply type the desired
command and press [ENTER].
Table 7 shows what keystrokes to use as you type commands or
view displays. See Table 8 for more information on UPS
commands.
Table 7. Keystroke Commands
Action Key Sequence
Delete last character typed. [BACKSPACE] or [CTRL]-[H]
Delete line. [CTRL]-[X]
Pause displays that take more than one screen. [CTRL]-[S]
Resume scrolling. (Turn Pause off.) [CTRL]-[Q]