Product Manual

Save These Instructions 4
Flood Pump System
5
. Begin vacuuming the water. The pump will automatically dis-
charge water when the water level reaches the proper height in
the recovery tank. If the water level falls too low. The pump will
automatically shut off to prevent itself from running dry.
CAUTION: Check the recovery tank for excessive foam while
operating. Foam could result in motor damage.
6. When the recovery tank is full, the float system will shut off
p
ower to the vacuum motor and prevent water from entering
the motor. The float may not work properly if it is extremely
dirty or if there is excessive foam in the tank. Once the tank
is sufficiently emptied, the vacuum will automatically come
back on.
MAINTENANCE
To keep the machine in good working condition, maintenance
procedures should be followed after each use.
CAUTION: When servicing machine turn the power off and
unplug the machine from the
wall outlet.
1. Drain and flush the recovery
tank, intake hoses, and any
wand or hand tool used with
clean water. Make sure the
discharge connector is
closed.
2
. Thoroughly clean the inlet basket filter.
3. Inspect power cords for damage. Replace damaged cords and
plugs immediately. Do not use the machine with a damaged
cord or plug.
4. Inspect vacuum hoses for holes and loose cuffs.
5. Clean machine housing with an all purpose cleaner and damp
c
loth.
6. Inspect the machine for leaks and loose hardware.
7. Lubricate wheels and casters with oil or grease .
STORING
1. Machine should be completely empty and dry
before storing.
2. Store machine in a dry area in the upright
position.
3. Open recovery tank cover to promote
air circulation.
CAUTION: Do not expose to rain or
freezing temperatures, store indoors.
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Poor pick up. Inlet basket filter is clogged. Clean filter.
Loose drain hose connection. T
ighten drain hose.
Loose recovery tank lid. Position the lid correctly.
Damaged hose. Replace hose.
Vacuum motor does Unplugged cord. Check connection to pigtail and wall
not operate. Faulty switch or loose wiring. Contact Service Center.
Tripped building circuit breaker. Reset breaker.
Defective vacuum motor. Contact Service Center.
Discharge pump does Unplugged cord. Check connection to pigtail and wall
not operate. Faulty pump switch. Contact Service Center.
T
ripped building circuit breaker.
Reset breaker
.
Defective pump motor.
Contact Service Center
.
Amount of discharge
W
orn impeller
.
Contact Service Center
.
water dwindles.
X9209 Manual 12/12/05 9:34 AM Page 5