Exercise Bike User Manual

page 24
7. Test the Hall 1 speed sensor by SLOWLY moving the pedals. Continue
pedaling for about 1 minute. The asterisk to the right of “Hall 1” will blink on
and off if the sensor is working correctly. If the asterisk stays solid, the cycle
needs servicing. Please note that only Hall 1 is used; ignore Hall 2.
8. To exit the Diagnostic program, either turn the cycle OFF then ON, or press
ENTER/RESET three times. In either case, the initial start-up prompt,
“Choose Workout Program,” appears.
Getting Service
Do not attempt to service an EC850 cycle yourself except for the maintenance
and diagnostic tasks described in this manual. The EC850 cycle does not
contain any user-serviceable parts.
To contact a Precor Commercial Products Customer Service Representative,
call 1-800-347-4404.