Exercise Bike User Manual

page 5
2
Setting Up the EC850 Professional Cycle
The EC850 Professional Cycle comes fully assembled. You simply need to
follow the installation requirements listed in this section and place the cycle in
the appropriate location.
The cycle has a unique program that lets you determine which language and
measurement system appears on the electronic console display. You can
choose one of three languages: French, German, or English, and select either
U.S. Standard or Metric as the measurement system. The Club Setting Program
also enables you to limit workout time on the cycle so more people can use it.
Instructions on how to use the program are found in this section.
Installation Requirements
Follow the installation requirements below when installing the cycle. If you do not
install the cycle according to the following guidelines, you could void the Precor
warranty.
• Set up the EC850 cycle on a solid, flat surface.
• Use the appropriate voltage outlet and grounding as specified on the
cycle. The EC850 cycle is available in both 120-volt and 220-volt models.
Refer to the cycle’s identification label to determine the voltage and fre-
quency that your cycle needs.
CAUTION: Do not use a non-grounded outlet. Electrical damage might
occur if the EC850 cycle is connected to an improper power source.
Interconnecting Cycles
You can connect up to eight EC850 cycles together in a “daisy chain” fashion
which eliminates the need for additional wall outlets.
To connect the cycles together, take the following steps:
1. Locate the outlet on the front of the cycle next to the ON/OFF power switch.
2. Connect the appropriate power cord from the outlet to the next cycle in line.
Caution: Do not use the outlet located on the front of the cycle for anything
other than interconnecting EC cycles. Do not connect treadmills or other
electrical appliances to this outlet.