EH1266 1.
IMPORTANT Installer and Users please note: These instructions should be read carefully and left with the user of the product for future reference. INSTALLATION For free-standing use: attach the feet to the underneath of the heater using the four 12mm (½") screws. To wall-mount: Firstly, remove the lower brackets from the back of the heater, turn them upside down and replace them, so that the tags protrude below the heater.
DRILLING DIMENSIONS FOR WALL MOUNTING 250mm 250mm 308mm Page 3 233mm 233mm
PRODUCT SAFETY • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. • Children should be supervised to ensure that they do not play with the appliance • Place the EH1266 on a firm flat surface.
OPERATION Plug the mains lead into a 13 Amp mains socket. If connecting via an extension lead, make sure that the lead is rated at 10 Amps or more, and that it is fully unwound. Switch the unit on at the mains socket. Use the two switches on the side to select the required operation: • One switch on = Low Heat (750W) • Both switches on = High Heat (1500W) Do not touch the air output grille when the heater is in operation, because it will be hot and may cause burns.
OPERATING COSTS At time of going to press, the average cost of electricity is £0.11 per unit (kilowatt-hour). The amount you are being charged will be shown on your electricity bill. At this cost, the EH1266 will cost £0.08 per hour to run on the "low heat " setting, and £0.16 per hour to run on the "high heat" setting with the thermostat set to its maximum. If the thermostat is used to regulate the temperature the operating costs will be lower, depending on the room temperature.
FAULT-FINDING The EH1266 has an overheat protection switch, which disconnects the power if the element gets too hot. The usual reason for this is because the air-flow has been obstructed, or the grilles have been blocked. If the heater ceases to operate, leave it for 20 minutes to cool down, then check that the grilles are not being obstructed. Switch back on, and check that the unit is operating normally. If not, contact an authorised service agent for repair.
SERVICE WARRANTY Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of twelve months. This Elite product is guaranteed for a further twelve months subject to the enclosed registration card being completed and returned to the address printed on it, or the registration form being completed on-line at www.prem-i-air.
