Installation manual

AM3-B
Installation Manual Page - 11 -
Universal Mounting Bracket Assembly
1. Place the universal bracket bar and the universal brackets on a flat surface.
2. Slide the universal brackets onto the universal bracket bar (as shown in Figure 9) with the set screws
facing up. At this time, do not tighten the set screws that are located on the universal bracket.
3. Place the display on a soft, flat surface, face-down. Next, place the universal bracket assembly on the back
of the display, with the universal brackets resting directly over the display mounting points.
4. Once the desired position has been determined, place the Griplate™ over each mounting point (dimples
facing up) and secure them using the appropriate hardware (see Page 5).
NOTE
: If spacers are to be used, they must be placed between the display surface and the universal
mounting brackets.
5. At this time, center the universal bracket bar and tighten the set screws that are located on the universal
brackets.
NOTE: For the two upper mounting points, the dimples (Griplate™) must be facing up. For the two
lower mounting points, the dimples (Griplate™) must be facing down.
Griplate™ Display Universal Bracket Bar Griplate™
Figure 9
Set
Screw
Set
Screw
Dimples Facing
Up
Universal Mounting Brackets
Griplate ™
M4 M5 M6 M8