Installation manual

AM3-B
Page - 14 - Installation Manual
Tilt Positioning
NOTE: To adjust the display, loosen the tension
bolts no more than ½ turn, make the
adjustments and then tighten the tension
bolts.
When tilt positioning is needed to adjust the display,
place a hand at the top corner of the display and the
other hand at the bottom of the display (Figure 15).
To Tilt the Display
Gently push both hands inward. This motion will
cause the display to tilt forward.
To Tilt the Display Back
Gently push both hands outward. This motion will
cause the display to tilt forward.
Figure 15
Cable Access Holes
Once the display has been mounted and adjusted,
route the cables through the cable access holes and
to their respective locations (Figure 16).
Figure 16
Cable Access Holes
Tilt / Pivot
Point