User's Manual

10
- Turn on the power while pressing the t key (2b) to enable (BP on)
or disable (bP oF) the KEY BEEP function.
- When function is activated, “BP” appears on the display.
3) TOT (Time Out Timer) (CB/PA key)
If the transmission key is longer than 5 minutes, CHANNEL and ac-
tivated or deactivated
start blinking, the transmission ends.
The time-out tone will sound until the PTT key is released.
The TOT function can be activated or deactivated as follows:
- Turn on the power while pressing the CB/PA key (6) to enable (t
on) / disable (t oF) the TOT function.
4) COLOR (EMG + CB/PA keys)
- Turn on the power while pressing the EMG (5) and CB/PA (6) keys.
Symbol of the current color, among the seven, blinks, (red),
(green), (blue), (cyan), (yellow), (purple) or (cyan
light).
- Use the s/t keys (2) to change the color.
- When the color is set, long press the F key (5). Beep sounds, the
characters of the color are displayed during 1 second.
D) FUNCTIONS WITH PTT SWITCH
2 more functions are available. To activated the function press
and hold the PTT switch (8) and press the function key. Repeat this
process to deactivate the function.
1) TALKBACK (PTT + F)
The TALKBACK function can be activated or deactivated as follows:
a) Press and hold the PTT switch (8)
b) Short press on F key (5). Current TALKBACK level blinks 3 times al-
lowing you to adjust this level.
When function is activated, “TALKBACK” appears on the display.
This function allows to ear your own modulation with the CB speaker.
2) TALKBACK LEVEL (PTT + s/t)
- At step b) adjust the TALKBACK level using the s/t keys (2) on the
unit.
- When the function in on and “TALKBACK” is shown on the display,
press and hold the PTT switch (8), then use the s/t keys (2) on the
unit. 9 levels from 01 to 09.
A) DC-POWER TERMINAL (13.8 V / 27.6 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 Ω, Ø 3,5 mm)
D) PA SPEAKER JACK (8 Ω, Ø 3,5 mm)
E) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels : 40
- Modulation modes : AM
- Frequency ranges : from 26.965 MHz to 27.405 MHz
- Weather channels : 162,400 MHz to 162,550 MHz
- Antenna impedance : 50 ohms
- Power supply : 13.8 V / 27.6 V
- Dimensions : 4.92 (W) x 6.89 (D) x 1.77 (H) inches
125 (W) x 175 (D) x 45 (H) mm
- Weight :
~
1.98 lbs / 0.9 kg
- Accessories supplied : Electret microphone with support,
mounting cradle, screws
- Filter : ANL (Automatic Noise Limiter) built-in
2) TRANSMISSION
- Frequency allowance : +/- 200 Hz
- Carrier power : 4 W RMS
- Transmission interference : inferior to -60 dBc
- Audio response : 300 Hz to 3 KHz
- Emitted power in the adj.
channel : inferior to 20 µW
- Microphone sensitivity : 3 mV
- Maximum drain : 1.8 A at 13.8 V / 0.9 A at 27.6 V
- Modul. signal distortion : 1.8 %
English
Andy ASC AM 12_24 V 4 langues US_v1.01.indd 10 04/05/2017 09:17:34