User Manual

OPERATION
12
2.3 ADVANCED MODES
To enhance the Monitor Station’s functionality, the behavior of the input LED meter and Speaker Select, Main
Source and Cue Source buttons can be changed to best suit your studio environment.
Enter the following modes by pressing and holding the specified buttons while powering on the Monitor Station.
Only one mode can be set at a time. The Monitor Station remains in the selected modes until another is selected.
2.3.1 Speaker Select Modes
• Combo
The default Speaker Select mode.
In Combo mode, all Speaker Select buttons can be active
simultaneously.
• Toggle
Restricts Speaker selection.
In Toggle mode, only one Speaker Select button can be
active.
This mode is primarily used when referencing your audio
source across different sets of studio monitors.
• Toggle A/B
Restricts Speaker A & Speaker B selection.
In Toggle A/B mode, Speaker A and Speaker B cannot
be active simultaneously. Speaker C can remain active
at all times.
This mode is primarily used if Speaker C is a subwoofer.
2.3.2 Main and Cue Source Modes
• Input Sum
The default Source mode.
In Input Sum mode, all Main and Cue Source buttons can
be active simultaneously.
• Input Toggle
Restricts Source
selection.
In Input Toggle mode, only one Main Source and one Cue
Source button can be active.
This mode is primarily used when comparing the Monitor
Station’s audio sources to each other (such as when A/B’ing
your mix against a commercial CD).