Dynamic DX Finger Steering Control G! NIINNDRY WEAOR NLY S US ITION D CON Basic Operation Instructions
Basic Operation Instructions Finger Steering Control IMPORTANT NOTICE This manual describes basic operation for the Dynamic DX Finger Steering Control only and must be read in conjunction with the ownerÂ’s manual supplied with your power chair. Please read both manuals in their entirety before operating the Dynamic DX Finger Steering Control or your power chair. This manual is intended as a supplement to the in-service training provided by your authorized provider.
Finger Steering Control Basic Operation Instructions 3 TABLE OF CONTENTS INTRODUCTION ................................................................................ 4 Dynamic DX Finger Steering Control ....................................................... 4 ACTIVE/STANDBY MODES ........................................................... Switching Modes ....................................................................................... Active Mode Operation ........................................
Basic Operation Instructions Finger Steering Control INTRODUCTION Welcome to Quantum Rehab, a Division of Pride Mobility Products Corporation. Quantum Rehab is dedicated to the customization of power chairs for users with advanced rehabilitation and mobility issues. Quantum Rehab also expands possibilities for enhanced healthcare attendant control over power chair functions to provide a secondary level of support for our customers where necessary.
Finger Steering Control Basic Operation Instructions 5 Status LEDs Green indicates fault codes; red indicates whether the Finger Steering Control is in Active Mode or Standby Mode. Finger Steering Control Detects the position of the user's finger and translates that into an executable command. Active/Standby Switch Toggles between Active and Standby Modes and scrolls through drive programs and actuators.
Basic Operation Instructions Finger Steering Control NOTE: The Finger Steering Control should only be used in dry conditions or where sufficient protection from moisture can be maintained. Allow the control to dry thoroughly if it has been exposed to moisture. ACTIVE/STANDBY MODES The Finger Steering Control utilizes two modes—Active and Standby. Active Mode allows the user to drive the power chair, while Standby Mode does not.
Finger Steering Control Basic Operation Instructions 7 Actuator Control While in Active Mode, hold your finger on the Active/Standby Switch to scroll through the drive programs and actuators. When you reach the actuator you wish to adjust, take your finger off of the switch. Place your finger in the neutral position of the finger area, then slide your finger down to extend the actuator or up to retract the actuator.
Basic Operation Instructions Finger Steering Control ! INDG RY N WAR IN ONLY USE ITIONS D CON Exeter, PA Quantum Hotline: 1-866-800-2002 Visit the Rehab Zone at: www.quantumrehab.