User's Manual

Reboot:

1. Unplug the AC power adaptor and replace the phone with new fresh batteries.

2. When the new batteries are replaced, re-plug in the AC Power Adaptor and the LCD

will glow back on and

icon on the display will disappear.

Replace the battery of the Pendant:

The pendant is equipped with a pre-installed internal battery. Each time the red key is

pressed, the led will light to show correct transmission. In case the led does not light

on, please change the battery with a new one

1. Use a Philips screwdriver to remove the screw on the lower case of the pendant and

remove the lower case.

2. Replace the 12V DC battery with a fresh one.

3. Replace the lower case and secure it with the screw.

Connecting the plug-in AC adaptor

Insert the plug of the power supply into the power

socket on the back of the telephone and plug the

adaptor into wall socket. For safety reasons, use

only the adaptor provided. Plug the adaptor to

the socket-outlet which is near the equipment and

should be easily accessible.

In case the telephone is not connected to the

adaptor (and with no charged batteries), it will maintain the basic telephone feature of

dialing and receiving a call. No other features will be working.

Connecting the telephone line

1. Plug one end of the telephone line cord

into the TEL. LINE at the back of the

telephone base.

2. Plug the other end of the telephone line

cord into the wall outlet.

3. Plug one end of the coil cord into the

handset's modular jack.

4. Plug the other end of the coil cord into the

left side of the telephone base.

Lift the handset to check for a dial tone.