User's Manual

40
repeat a second cycle of emergency calls and at the end stop the emergency
procedure (SOS icon will then turn off).
Note:
1. If NO emergency numbers have been set, the telephone will not dial anything and just
beep loudly continuously when the emergency SOS key on the telephone, or the key
of the pendant is pressed for more than one second.
2. It is important that the pendant must be within the range of the telephone to activate
the emergency feature. The user should check that between the pendant and the
telephone there are no structural obstacles, heavy concrete walls, etc.
3. When the red key on the pendant is pressed, the led on the pendant will light up for
as long as the key is pressed. If the led does not light up it is necessary to replace
the battery.
4. To stop the ongoing emergency feature, press and hold for more than three seconds
the emergency button on the telephone, or press and hold the button of the pendant
for more than three seconds Engaging the line through the handset or the
speakerphone SPEAKER button will also stop the ongoing emergency feature.
When the emergency feature is off the SOS icon will also turn off.
5. The emergency feature will automatically stop when all the emergency numbers have
been dialed or if the receiver presses 1 and 2 after the 0 key. [The reason for
interrupting automatically the call after 3 minutes is for safety in case a receiving
party presses 0 but for any reason is unable to receive the message, in case of
mobile phone line failure for example]
6. The receiving party is expected to press 0, 1, 2 with a touch-tone phone, a
standard feature in most telephones.
The following is a brief explanation on the above
*Please note: If 1 and 2 buttons are pressed by the receiving party after they have
pressed 0 to accept the emergency call, the speakerphone will keep active until the
speaker button on the phone or the pendant button is pressed to disconnect the call.