Assembly Instructions

[phone]
Primo All-In-One
Cradle Assembly Instructions
www.primogrill.com
(FOR PRIMO OVAL AIO MODELS: JR 7400, LG 7500, XL 7800)
ONE (1)
CROSS BRACE
1
2
3
54
COMPLETED ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY:
ADJUSTABLE WRENCH OR 10MM & 11MM WRENCH
LARGE PHILLIPS HEAD SCREWDRIVER
HARDWARE
COMPONENTS
TWO (2)
SIDE SUPPORTS
TWO (2)
STABILIZERS
TWO (2)
BASE SUPPORTS
FOUR (4)
SHELF BRACKETS
TWO (2)
SIDE SHELV ES
FOUR (4)
M6X20 THREADED
STUDS
FOUR (4)
M6 LOCK NUTS
USED IN STEP 2 & 5
FOUR (4)
M6X16 FLAT PHILLIPS
HEAD SCREWS
USED IN STEP 3
FOUR (4)
M6 ACORN NUTS
USED IN STEP 4
A
B
B
A
90º
SIDE SHELF BRACKET ASSEMBLY
OVAL JR & LG AIO
Fasten 4
self-tapping
screws per shelf
in outer
mounting holes.
Fasten 4
self-tapping
screws per shelf
in inner
mounting holes.
OVAL XL AIO
EIGHT (8)
SELF-TA PPING
PHILLIPS HEAD
SCREWS
SIDE TABLE SCREWS
ASSEMBLY INSTRUCTIONS
Remove all parts from the packaging and compare to the parts list. Refer to the
numbered drawings (left) for assembly guidance.
1 Holding base support B on the floor insert base support A through B as shown.
Twist base support A into the upright position as shown in step 2.
2 Align the center holes as shown. Insert the 2 M6X20 threaded studs through the
top of the center holes and attach 2 M6 lock nuts from below the assembly.
FINGER TIGHTEN ONLY AT THIS TIME
3 Insert 4 M6X16 phillips head screws through the holes in the base support
uprights with the threads facing outward of the assembly. Align the 2 side
supports over the fasteners.
4 Align one of the stabilizers over the fasteners and attach 2 M6 acorn nuts.
Repeat for the opposite side of the assembly. FINGER TIGHTEN ONLY AT THIS
TIME
5 Insert 2 M6X20 threaded studs in each hole toward the center of the base
supports, threads facing downward. Align the cross brace from below and fasten
2 M6 lock nuts to the screws. Tighten ALL fasteners with an adjustable or 10MM
& 11MM wrench and phillips head screwdriver.
Note: Locking casters should
face forward on the long side.
Note: If side shelves are not level or
sagging, loosen the 2 acorn nuts, pull
upward on the side supports and
tighten the acorn nuts firmly.