Installation Guide

17 1/4 ’’
6 1/4’’
UNPACKING AND TESTING APPLIANCE
Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the
appliance operates properly by plugging the power supply cord into a conveniently located 110-120 Volt
grounded outlet.
【Grounding Appliance】
This appliance is for use on 110 Volts.
For connecting three-blade grounding type plugs to three -slot
receptacles. The green grounding lug extending from the
adapter must be connected to a permanent
ground such as
a properly grounded outlet box. The adapter should not be used if a three-slot grounded
receptacle is available. To disconnect appliance, turn controls to off, then remove
plug from outlet.
WARNING:
Keep the front of the appliance through which the heat is radiated at least 1 meter away from furniture,
curtains and
other flammable objects at all time.
Never use an extension lead. The mains cable must
remain
at the back of the appliance and must not be in contact with any hot elements.
【INSTALLATIO
N
】
WARNING: Find a safe location and build a suitable hole for fireplace. Minimum clearance from the ceiling and the
mantel
must be at least 8 inches(200mm);
minimum clearance from the front must be at least 3 feet(900mm). Choose a
location near an outlet so an extension cord is not required.
Take model BI50G as an example. Prepare a wall with a framed opening of 49 inch(1244.6mm) width X 17.25’’(438.2mm)
high. Make sure the width of the wood block on both sides which used to fix the fireplace is 3’’(76mm). Make sure that the
revealed wood block width on both sides is about 1 1/2’’(38.1mm) after finishing the plasterboard. Measure the depth
D from the plasterboard surface to the wood block and write it down.
MODEL
BI36G
BI40G
BI45G
BI50G
BI60G
BI72G
BI88G
BI95G
A
35 ’’
(889 mm)
39 ’’
(990.6 mm)
44 ’’
(1117.6 mm)
49 ’’
(1244.6 mm)
59 ’’
(1498.6 mm)
71 ’’
(1803.4 mm)
88 ’’
(2235.2 mm)
94 ’’
(2387.6 mm)