User Manual
Blackjack 29
1. Carefully place the boat in the water.
2. Operate the boat at slow speeds near the shoreline.
Avoid objects in the water at all times. When the
boat is moving forward, ensure water flows out of
the coolant outlet. Remove any blockage from the
rudder inlet and coolant system or the motor and ESC
(electronic speed control) may overheat.
3. Once you are comfortable operating the boat at
slow speeds, it is safe to operate the boat farther
from the shore.
If you are using too much steering trim on your
transmitter to make the boat drive straight, return the
trim to neutral and mechanically center the rudder.
To do this, loosen the ball link from the rudder horn,
then turn the ball link on the linkage threads until the
rudder is properly centered.
4. Bring the boat back to shore when you notice
the boat starting to lose speed.
5. Power off the ESC and disconnect the battery packs.
6. Allow the motor, ESC and battery packs to cool before
charging the batteries or operating the boat again.
Do not turn off the transmitter first
or the receiver may pick up stray signals and
run out of control.
Avoid boating near other watercraft, stationary objects,
waves, wakes and other rapidly moving water, wildlife,
floating debris or overhanging trees. You should also be
careful to avoid boating in areas where there are many
people, such as swimming areas, park waterways or
fishing areas. Consult local laws and ordinances before
choosing a location to pilot your boat.
Maximum speeds are only achieved when the water
conditions are smooth and there is little wind. A sharp
turn, wind or waves can turn over a boat when it is
moving quickly. Always pilot your boat for the wind and
water conditions so that the boat does not turn over.
When running your boat for the first time, we
recommend calm wind and water conditions so that
you can learn how the boat responds to your control.
When making turns, decrease the throttle position
in order to decrease speed and probability of flipping
the boat over.
When running at full speed in choppy
waters, the prop may exit and re-enter the water
repeatedly and very quickly, subjecting the propeller
to some stress. Frequent stress may damage
the propeller.
Never retrieve your boat from
the water in extreme temperatures, turbulence
or without supervision.
8
EN
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifier) code of
a single specific transmitter. The DX2E and MR200 are
bound at the factory. If you need to rebind, follow the
instructions below.
1. With the receiver off, insert the
bind plug into the BIND port on the
receiver.
2. When the batteries are connected
to the ESC and the ESC is
connected to the throttle port on
the receiver, power on the ESC switch. An LED on
the receiver will flash rapidly, showing the receiver is
in Bind mode.
3. Do not touch the throttle or steering controls, as this
sets failsafe settings. The throttle and throttle trim
should always be at the lowest setting during bind
mode. Press and hold the bind button and power
on the transmitter. The green LED on the front of the
transmitter will flash within three seconds, indicating
the transmitter is in bind mode.
4. Release the bind button when the green LED flashes.
BIND THST
N R N R
5. The receiver's LED will turn solid when
the transmitter and receiver are bound.
6. Remove the bind plug and store it in
a convenient place.
• Different failsafe positions are desired e.g., when
throttle or steering reversing has been changed.
• Changing receiver types e.g., changing from a DSM
®
receiver to a DSM2
®
or Marine receiver.
• Binding the receiver to a different transmitter.