Operation Manual

8
7. Attach the Console Back (104) to the console assembly
with five 3/4” Screws (33). Be careful not to damage
any wires.
104
33
Console Assembly
33
33
7
5. See the inset drawing. Make sure that there are two U-
nuts (112) in the upper end of each Upright (96). Note:
Extra U-nuts may be included.
Identify the right and left Handrails (108) (there is an
i
dentification sticker on each Handrail). Hold the right
Handrail near the right Upright (96), and insert the Wire
Harness (118) into the large hole in the right Handrail
and out of the upper end as shown.
Next, hold the right Handrail (108) against the right
Upright (96). Tighten a 5/16” x 3 1/2” Bolt (121), with a
5/16” Washer (130), three to four turns into the right
Upright and the lower end of the right Handrail. Then,
tighten two 5/16” x 1” Bolts (113) into the upper end of
the right Handrail and the right Upright.
Be careful not
to drop the Bolts into the Handrail.
If necessary, raise
or lower the Handrail to thread the 5/16” x 1” Bolts into
the Upright. Firmly tighten all three Bolts.
Attach the left Handrail (108) to the left Upright (96) as
described above. Note: There is not a wire harness in the
left Upright.
6. See the inset drawing. Turn the Console (101) upside-
down on a soft surface. Remove the packing bands and
the Console Back (104).
If there are two Pulse Bar Screws (76) in each end of the
Console Frame (80), remove them. Hold the ends of the
Pulse Bar (77) against the Console Frame and attach the
Pulse Bar with the four Pulse Bar Screws. Firmly tighten
the Pulse Bar Screws. Be careful not to damage any
wires.
Locate the pulse wire extending from the Pulse Bar (77).
Insert the pulse wire under the Console Frame (80) and
plug the pulse wire into the indicated connector. The
pulse wire should slide easily into the connector and
snap into place; if it does not, turn the pulse wire and
then plug it in.
Attach the indicated ground wires to the Console Frame
(80) with a 1/2” Ground Screw (52).
5
96
118
96
108
108
1
13
1
13
121
Right
Left
121
119
112
130
130
76
52
77
101
80
6
104
101
Pulse
Wire
Connector
Ground
Wires