User`s manual

6. Attach the Backrest (10) to the Backrest Frame (5)

with two M6 x 16mm Screws (64), an M6 x 50mm

Screw (69), and an M6 Flat Washer (71).

Slot

Knob

5. Attach the Seat (12) to the Seat Frame (6) with three

M6 x 16mm Screws (64).

7. While another person holds the Upright (13) in the

position shown, connect the Upper Wire Harness (35)

to the Lower Wire Harness (36). Carefully pull the

upper end of the Upper Wire Harness to remove

any slack from the Wire Harnesses.

Turn the Knob (not shown) on the right side of the

Frame (1) counterclockwise two or three turns to

loosen it. Next, pull the Knob, insert the Upright (13)

into the Frame, and then release the Knob. Move the

Upright up and down slightly until it locks into

position. Be careful to avoid pinching the Wire

Harnesses (35, 36). Tighten the indicated M6 x

25.4mm Button Screw (79) into the slot in the Upright.

8. While another person holds the Console (16) in the

position shown, connect the wire harness on the

Console to the Upper Wire Harness (35). Insert the

excess wire harness into the Upright (13).

Attach the Console (16) to the Upright (13) with four

M4 x 16mm Screws (73). Be careful to avoid pinch-

ing the wire harnesses.

Attach the Water Bottle Holder (89) to the Upright (13)

with two M4 x 22mm Screws (91).

Wire

Harness