Owner`s manual

ManualsBrandsPro-Form ManualsElliptical TrainerDR852040

TROUBLE-SHOOTING AND MAINTENANCE

inspectand tighten all parts each time you usethe CROSS TRAINERe. Replace any worn parts immediately. Outside

surfaces of the CROSSTRAINER • can be cleaned usinga damp clothand mild detergent. Keepall liquidsaway from

Ihestepper consoleand the PERSONALTRAINERcomputer.Most CROSSTRAINER• problemscan be solvedby follow-

ing Itm stepsbelow. Findthe applicable symptomand follow the step(s) listed.If furtherassistanceisneeded, .callour

CustomerServiceDeporlment tall-freeat 1-800"999-3756, Monday through Friday, 6 a.m. until6 p.m. Mountain

Time(excluding holidays).

1. SYMPTOM: THE PERSONAL TRAINER COMPUTER DISPLAYSAN ERRORCODE ("EEE")

a. While theweightsefllngischanging,_ motorwill be heardand theSETSand PEPSdisplayswill showa rapidly

rotatingindicator. To preventdamage ta.the weight system,do notput any pressurean the leg developer,arms

or cableswhile theweight settingis cbanglng. If the lat bar or rawer bar is attachedto the highpulley station,restit

in theracknear the high pulleystation.Wait for the soundof the motor tostop before you continue. IFthe comput-

er sensespressure on the weightsystemwhile theweight settingischanging, theWEIGHT display will showan

error code ("EEE') for two seconds,and theweight settlng will stopchanging. TheWEIGHT displaywill then show

the currentweight setting. Make sure thatthere is no pressureon the leg developer, arms or cables. Pressthe

increaseor decrease buttan beneath the WEIGHT display to change the weight seltingas desired.

2. SYMPTOM: THE MAIN CABLEDOES NOT MOVE SMOOTHLY, OR THERE ISSLACK IN THE MAIN CABLE

a. Inspectthe routingof thecables and make surethat they are in the grooves in all of the pulleys.If they are not,

correctthe problem. If the cables are not properly routed, they will be damaged when used.

b. If there isslackin the Main Cable (51), locatethe

AdjustmentBracket(53) near the bottom of the

right side shield.Hold the end of theWeight Cable

{52) firmly, and slide the AdjustmentBracketfar-

ther ontothe Weight Cable. Tightenthe 5/16" Nut

(82) against theAdjustmentBracket.Testt_ Main

Cable. If the motar stalls or hesitates,loosenthe

5/16" Nut slightly. If the 5/16" Nut is tightened as

far as possibleand there is stillslack,the Main

Cable shouldbe replaced. See ORDERING

REPLACEMENTPARTSan the back coverof this

_*Tl_l S monuol.

3. SYMPTOM: THE STEPPERCONSOLE DOES NOT

FUNCTION PROPERLY

a. youstep,movethestepperpedalsverticallyat

least8 inches.Ifyour stepsare too shallow, the

movementof the stepperpedalswill not be detect-

ed. Ifthe stepper consolestilldoes not function

properly, the ReedSwitch(99) can be adjustedby

slidingthe barrel of the Reed Switch up and down

slightly.Repeat untilthe stepperconsoledisplays

correctfeedback. If necessary,the 3/4' Screw

(119) at_:hing the Reed SwitchBracket(120) can

be loosenedand the position oFthe Bracketcan be

adjusted.

53 52

119

/V_ounting

eeve