Owner`s manual

ASSEMBLY

Assemblyrequirestwo persons.To assemblethe CROSS TRAINER e, usethe includedvideacassettoor follow the

instructionsbelow. Due to the weight of the CROSSTRAINERe, it shouldbe assembledin the locationwhere itwill be

used. Placeall partsin a clearedarea and remove the packing materials. Do not disposeof the Packing materialsuntil

assemblyiscompleted.Make sure to lower the resistancecylinders and pedals before beginning assembly;,if the

resistancecylindersfall, Ihey may damage Ihe side shields.Read each assemblystepand examine each drawing

carefully. Make sure that all parts are oriented as shown in the drawings.

The following tooJs (not included)ore required for assembly:, two 8' Adjustob.leWrenches _ and a

Rubber Mallet _. A small amountof soapywater isalso requered.

1. Set the FrontBose(7) and the Rear Base(8) on the

floor as shown.Tum the Rear Bose so the indented

holes are toward thefloor.

Insertseven3/8" x 2 1/2" CarriageBolls(1) up

through theindicatedholesin theFrontand Rear

Bases(7, g}.

With the help of a secondperson, settheTower

Frame (1O) near the indicatedendsof theFrontand

Rear Bases(7, 8). The Tower Frame mustbe turned

so the Pedals(75, 76) are on the some sideas the

extensionon the FrontBose. Raisethe Tower Frame

and lower itonto the two indicated 3/8" x 2 1/2"

Carriage Bolls (1) in the Rear Bose.

3. Raisethe front of theTower Frame (10) and lower it

onto the two indicated3/8" x 2 1/2" Carriage Bolls

(1) in the FrontBase(7).

Adjust thepositionof the Tower Frame (1O)so the

four indicated 3/8" x 2 1/2" Carriage Bolts(1) are

centeredin the slottedhobs in the Tower Frame.

Thread a 3/8" Nut (2) with a 3/8" Lockwosher(3)

onto each Carriage Bolt.Do not tighten the Nuts

yet.

1 7

Extension

Extension 3