Owner`s manual

14. Attach the Seat (28) ta the Uprlght (9) wlth the two 14
1/4" x 3/4" Bolts(20) and a 1/4" x 2" Bolt(118).
15. CenteronePadTube (22) intheUpright(9), andthe
otherPadTubeinthe LegDeveloper(23). Slide
four Small Pads (171onto the _ds of the PadTubes.
16. Restthe LeftandRightPedals(75, 76] onthehooks
at thelower endsofthe ResistanceCylinders(84).
Make sumthat the hooksam fullyinsertedinlothe
sameslolsunderIsethPedals.
Plugthe Transformer (39) intothe jack located near
the _oottomof the RightSide Shield (12).
16
84
76
17. Make surethat all parts are properly tightened.The useo_call remaining parts will be explained in ADJUSTING
THE CROSS TRAINER e, beginning on page 8 of this owneds manual.
18. Before usingthe CROSS TRAINERe, testthecables and the pulleys.Make sure that the cables are in the grooves
in the pulleys.If the cablesdonot move smoothly over the pulleys, locate and correct the problem before using
the CROSSTRAINERe. If the cables are not properly muted, they will be damaged when used.
7