User`s manual

11
11. While a second person tips the elliptical forward,
a
ttach the Rear Ramp Cover (17) to the Ramp
(2) with four #8 x 2" Screws (68).
11
1
7
68
68
2
12. Make sure that all parts of the elliptical are properly tightened. Note: Some hardware may be left over
after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical.
Plug the power supply into the socket at the front of the elliptical (see HOW TO PLUG IN THE POWER
SUPPLY on page 12). IMPORTANT: If the elliptical has been exposed to cold temperatures, allow it to
warm to room temperature before plugging in the power cord. If you do not do this, the console dis-
plays or other electronic components may become damaged.