User`s manual

M4 x 16mm

Screw (80)–4

M8 Hex Nylon

Locknut (77)–4

M8 x 19mm

Screw (65)–4

M6 x 18mm

Screw (57)–6

M10 x 27mm

Screw (64)–4

M6 x 14mm

Flat Head

Screw (55)–1

M10 x 15mm

Screw (71)–2

M10 x 22mm x

1.5mm Washer

(63)–2

Barrel Nut (56)–1M8 x 55mm Screw

(61)–4

#8 x 1/2"

Screw (79)–6

M10 x 120mm Screw (58)–2

#8 x 2"

Screw (68)–4

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical in a cleared area and remove the packing

materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tool(s) and your own Phillips screwdriver ,

adjustable wrench , and rubber mallet .

Use the drawings below to identify small parts. The number in parentheses below each drawing is the key num-

ber of the part, from the PART LIST near the end of this manual. The number following the parentheses is the

quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the

hardware kit, check to see if it has been preassembled.