User`s manual

ManualsBrandsPro-Form ManualsExercise BikeZX2

nspect and tighten all parts of the exercise cycle reg-

ularly. Replace any worn parts immediately.

To clean the exercise cycle, use a damp cloth and a

mall amount of mild soap. IMPORTANT: To avoid

damage to the console, keep liquids away from

the console and keep the console out of direct

sunlight.

CONSOLE TROUBLESHOOTING

If the console does not display your heart rate when

you use the handgrip pulse sensor, see step 5 on

page 13.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. To adjust the reed

switch, you must first remove the left pedal, the left

disc cover, and the left pedal disc (see the instructions

below).

Using an adjustable wrench, turn the left pedal clock-

wise and remove it.

Next, rotate the Left Crank Arm (20) to a vertical posi-

tion with the end of the Left Crank Arm pointing

downward.

Using a flat screwdriver, release the tabs on each

point of the left Disc Cover (18). Carefully work the left

Disc Cover over the Left Crank Arm (20) and remove

the left Disc Cover.

ext, rotate the

Left Crank Arm

(20) to a vertical

position with the

nd of the Left

Crank Arm pointing

upward.

Rotate the left Pedal Disc (17) clockwise to release it

from the Left Shield (11).

Then, work the left Pedal Disc (17) upward and

remove it from the Left Crank Arm (20).

Locate the Reed Switch (57). Loosen, but do not

remove, the two M4 x 12.7mm Flange Screws (63).

Next, rotate the Left Crank Arm (20) until a Magnet

(55) is aligned with the Reed Switch (57). Slide the

Reed Switch slightly toward or away from the Magnet.

Then, retighten the M4 x 12.7mm Flange Screws (63).

Rotate the Left Crank Arm (20) for a moment. Repeat

these actions until the console displays correct feed-

back.

When the reed switch is correctly adjusted, reattach

the left pedal disc, the left disc cover, and the left

pedal.

MAINTENANCE AND TROUBLESHOOTING

Tab