Manual

Replacing batteries

Proceed as follows:

 Unlock and slide open the battery case cover

 Replace the battery.

Make sure the battery is the right way round !

 Close the battery case cover

Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V

Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at

the appropriate collection sites - usually located at supermarkets and drugstores.

Technical specifications Pro-Ject Pre Box RS

Tubes: 2 x ECC88 (6922)

Frequency response: 20Hz - 50kHz (0dB/-0,8dB)

Noise floor: 95dB (A weighted)

THD: 0,06%

Gain XLR and RCA outputs *: XLR 12dB / RCA 6dB for input In 1 and input In 4

XLR 6dB / RCA 0dB for inputs In 2 & In 3 and inputs In 5 & In 6

Pre out (Pre Out): 1 pair XLR sockets (balanced connection).

* Unbalanced connection via supplied connection cable (XLR  RCA)

Record Out (Out): RCA input In 1, gain -6dB

gain ratio input / output signal. RCA inputs In 2 & In 3, gain 0dB

Fixed output signal XLR input In 4, gain -6dB

XLR inputs In 5 & In 6, gain 0dB

Line-level inputs: 3 pair RCA/phono sockets and 3 pair XLR sockets

Input impedance: 150kohms for RCA input In 1 and XLR input In 4

30kohms for RCA inputs In 2 & In 3 and XLR inputs In 5 & In 6

Wiring XLR sockets: 1 ground, 2 “hot” and 3 “cold”

Outboard power supply: 20V/3A DC, suitable for your country's mains supply

Power consumption: 700mA DC, <1W in standby

Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V

Dimensions W x H x D (D with sockets): 206 x 72 x 200 (210)mm

Weight: 1950g without power supply

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,

please contact your dealer for further advice. Only when the problem cannot be resolved there should the

unit be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

Pro-Ject Audio Systems is a Registered Trademark of

H. Lichtenegger.

This guide was produced by: Pro-Ject Audio Systems

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.