Manualshelf

User Manual

ManualsBrandsPro-Ject Audio Systems ManualsReceivers and AmplifiersStereo Box
1234
© Audio Trade GmbH · Pro-Ject Stereo Box · Revision 1.6.10/1.8.10
2
Dear music lover,
thank you for purchasing a PRO-JECT AUDIO amplifier.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
!
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Help to protect the environment
If you are not going to use the amplifier for an extended period of time, e.g. vacation, we suggest to
disconnect it from the AC mains. Please be certain that the amplifier is in standby-mode prior to unplugging
the power supply from the AC mains.
Connectors
Trigger Switch
!
Make all connections whilst the amplifier is disconnected from the power supply.
!
Take care to connect the left and right channels correctly. The right channel is usually marked red,
the left channel black or white.
The red speaker terminals carry the positive signal (+), the black speaker terminals the negative
signal (–). Make sure the polarity of the connection is correct at each end of the cables.
Inputs
Line level sources such as CD player radio or TV can be connected to the input sockets marked In 1 or In 2.
Connection to the speakers
The output terminals accept loudspeaker cables terminated with 4mm ∅ Banana plugs, spades connectors
or naked wire.
!
Only connect one loudspeaker with an impedance not less than 4 Ohm per channel.
Remote switching
Optional Pro-Ject Switch Box. The Trigger Switch socket connects the input expander Pro-Ject Switch Box.
The Switch Box provides four extra line-level inputs.
A 30cm remote switching cable is supplied with the Pro-Ject Switch Box for connecting the Trigger Switch
socket of the Pro-Ject Stereo Box.
Do not use this socket for any other connections for which it is not designed.
Mains power connection
The unit is supplied with a power supply suitable for your country's mains supply. Check the label before
connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from the
power supply to the Power 20V socket before connecting the power supply to the mains.