User Guide

Debut PRO
Setup Guide
Getting started:
• Make sure to have enough space to unpack your turntable.
• Always unpack and setup in a clean environment.
• Please Do NOT throw away the packaging! If you need
service or want to return your product, please send it
in the original packaging including all inserts. In case of
damage due to alternative packaging your dealer cannot
guarantee a full refund.
• complete manual:
www.project-audio.com/en/product/debut-pro
1 32
Unpack all items from accessory bag: Remove dust cover carton from the box.
Lift the wrapped turntable out of the box.
a)
b)
c)
d)
e)
f) g)
a) Anti Skating Weight / Allen key
b) Round belt for 78 RPM
c) Standard at belt for 33/45 RPM
d) Adapter for 7“ singles / Allen key
e) Connect it E RCA cable
f) Gauge
g) Cartridge alignment protector
Carefully remove the covering.
5
6
4
7
Unpack the counterweight.
Unpack the power supply.
Unpack the platter.
If necessary, level the turntable by
adjusting the feet.
8 10
9
Put the at drive belt (c) on the pulley
and sub-platter.
11
Put the platter on the turntable.
The turntable should always be placed on
a at surface. Check with a spirit level.
Large pulley for round belt (78 RPM)
Put the counterweight in place.
Put the gauge (f) on the platter.
Remove the stylus protection cover.
12
14
1513
Remove tonearm twist tie.
Lower the tonearm with the lift.
18
Put the loop of the Anti Skating Weight (a)
in the second notch on the tonearm post.
Place the stylus on the gauge.
The stylus should read 20.
16
19
17
Balance the tonearm by turning the counter-
weight forwards and backwards on the rod.
When the gauge stays level, your
tracking force is set correct.
0°
Plug in power supply and Connect it E (e).
Yellow cable marks to the amplier.
20
21
Unpack dust cover and install it.
Connect to your hi-system and
enjoy your music!
23
22
Use the switch to select the
playback speed.
33 RPM
RIGHT: 45 RPM / 78 RPM
STANDBYMIDDLE:
LEFT: