INSTRUCTIONS FOR USE Pro-Ject VC-E
© Pro-Ject Audio Systems · VC-E · Revision 2020.02.
Pro-Ject VC-E Controls, features and connections 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Vacuum arm* (adhesive velvet strips attached) Clamp* (base plate) Fixing screw for base part of clamp* Ventilation outlet and drain hole Main switch with mains power cord socket Vacuum on/off switch Motor on/off direction switch Vinyl record (not included) Screwable clamp - top plate* with self-adhesive record label seal* with rubber for sealing record label Hexagon screw for motor flange height adjustment (see page 6) Spindl
Dear music lover, Thank you for purchasing a Pro-Ject Audio Systems record cleaning machine. In order to achieve maximum performance and reliability, please study these instructions carefully. Warning of a hazard for the user, the unit or possible misuse. Important notice. During assembly and adjustment small parts can be easily lost if they are not carefully placed in a suitable receptacle.
Using the unit Please ensure that all assembly and set up steps have been followed as outlined in this manual. All 3 rocker switches ("main switch", "motor" and "vacuum" should be in position "0"). Connect the power cord to the socket on the rear side of VC-E and turn the main switch to the "I" position. Place a record on the bottom plate. Using moderate force, thread the top clamp plate on the threaded tip of the centre spindle. Do not over-tighten.
Maintenance and cleaning Your record cleaning machine requires little to no regular maintenance. The internal tank has a substantial capacity and subsequently takes a very long time to reach full capacity. Common home use of the unit does not require to empty the tank. In rare case the tank should be emptied: 1. disconnect the mains cable 2. Turn the VC-E up to drain the unit reservoir to a big container. 3.
How to adjust the height of VC-E’s record clamp The VC-S is pre-adjusted to spec for normal standard 80 – 180 g records. There is enough headroom, so that the arm is optimally pressed against the record and the cleaning fluid can be completely removed. The vacuum arm works best when it is parallel to the record when operating and the adhesive strips is pressed gently on the surface of record.
Declaration of Conformity We, declare under our responsibility that the product is in conformity with the provisions of Directives: 2014/35/EU including amendments 2014/30/EU including amendments The following harmonised standards were applied: EN 60335-1:02+A1:04+A11:04+A2:06+A12:06+A13:08+A14:10+A15:11 EN 60335-2-2:10+A11:12+A1:13 EN 55014-1:06+A1:09+A2:11 EN61000-3-2:14 EN61000-3-3:13 EN55014-2:97+A1:01+A2:08 Pro-Ject Audio Systems a division of Audio Tuning GmbH 1050 Vienna, Austria, Margaretenstrasse
