User Manual

GM ‘99 Silverado, Sierra (not Sierra Classic) models

GM ‘00 and newer Silverado,Sierra models including HD models

CAUTION!

Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!

IMPORTANT NOTES FOR THIS INSTALLATION:

1. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the ~4” between parallel rows of

spot welds where the bed sill sits.

Side Bracket

Axle Center

Front of

Vehicle

Rear Edge of

Truck Bed

1/4 1.5-3

1/4 2

* Optional weld

pattern

Drivers side of 3/4 ton HD shown

30” Long Box

25 1/8” Short Box

Measure from rear edge of

truck bed to rear edge of

base rail

Long bracket

Short bracket

ROW 1

ROW 2

ROW 3

ROW 4

King pin centered over Axle

Note: Pull wire provided, may be needed

to install hardware in bracket thru frame.

Long Box Bed Sills

Short Box Bed Sills

Each base rail must have a

bolt in either of the marked

center holes. Check for

obstructions before drilling.

CAUTION!

Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.

Cequent Towing Products does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the

responsibility of the installer to prevent damage due to installation.