User Manual

FORD F-150 & F-250 THROUGH ’96 / ‘97 F-250 OVER 8500 GVW, F350 THROUGH ’97 /

1999 & NEWER F-250 & F-350 SUPERDUTY

CAUTION!

Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!

CAUTION!

Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.

Cequent Towing Products does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the

responsibility of the installer to prevent damage due to installation.

Front

Vehicle

Rear Edge of

Truck Bed

ROW 1

ROW 2

ROW 3

ROW 4

32 1/2” Long Box

and Short Box

Measure from Rear Edge of truck

bed to rear edge of base rail.

1/4 1.5-3

1/4 2

Axle CenterKing Pin Center approx.. 4” forward of Axle Center

Drivers side of F350 Super

Duty long box Shown

* Optional weld

pattern

Side Bracket

Long bracket Short bracket

Bed Sill

Each base rail must have a

bolt in either of the marked

center holes. Check for

obstructions before drilling.

IMPORTANT NOTES FOR THIS INSTALLATION:

1. On short bed vehicles, attach Driver’s Side forward bracket on Row 2 to avoid interference with fuel lines.

2. On vehicles with overload springs, switch position of long and short brackets.

3. May need to move base rail location +/- 1/2” to ensure frame brackets do not interfere with bed sills.