User Manual

ManualsBrandsPro Series ManualsFor the car7168 15K FIFTH WHEEL

DODGE ‘03 AND NEWER 2500 AND 3500 (REQUIRES 58186 BRACKET KIT )

28 5/16” Long Box

26 5/16” Short Box

Side Bracket

Front

Vehicle

Rear Edge of

Truck Bed

* Optional weld

pattern

Inside frame

King Pin Centered

over Axle Center

1/4 2

1/4 1.5-3

Use provided(30035 kit) tube

spacers and 4 1/2” carriage bolts

to attach through Bed Sill

Drill through

Bed Sill with

17/32” drill.

Open up hole

through truck

bed only with

1” dia. drill.

Drop tube

spacer

through hole

in truck bed to

avoid crushing

Bed Sill when

torquing 4 1/2”

carriage bolt.

**Rearward access hole

(in top of frame)

Measure from Rear

Edge of truck bed to

rear edge of base rail.

Long bracket

ROW 1

ROW 2

ROW 3

ROW 4

Bed Sill

CAUTION!

Read pages 2-3 of 30035 instructions before starting installation. Failure to do so could result in significant vehicle damage!

CAUTION!

Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.

Cequent Towing Products does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the

responsibility of the installer to prevent damage due to installation.

IMPORTANT NOTES FOR THIS INSTALLATION:

1. Tube spacers and 4 1/2” carriage bolts used to attach through rearward Bed Sill (Row 3).

2. **Rib neck bolts will need to be pulled through rearward access holes in frame with supplied pull wire (see below).

4. It is very important that

brackets in Row 2 are against

rear side of Bed Sill as shown.

Due to dimensional instability

in Bed Sill placement with the

Dodge truck, interference

could result when drilling in

Row 3. Observe caution note

below and double check all

areas prior to drilling.

5. Rear brackets can be

mounted to frame with (2)

bolts in any combination

of the three bracket holes.

6. *Due to tubular frames

having thinner walls than

previous C channel frames,

extra caution needs to be

used when mounting with the

optional welding.

3. Do not drill thru both walls of

frame. Drill only thru wall of

frame to which bracket is

mounted.

Drill 2 center holes shown in

addition to 8 holes for 30035

kit. Install 1/2” carriage bolts,

slotted spacer above or below

bed to fill bed corrugation, and

bolt plate below bed with

washer and nut.

Drivers side of 2500 Ram Long box Shown

1/4 2